Skip to main content

Rating of Multiple-Ply Belts

 Rating of Multiple-Ply Belts

Multiple-ply belts are now rated on the basis of tensile strength (in pounds-per-inch-width per ply) when the splices are vulcanized. With normal mechanical-fas tener splices, the rating is reduced to approximately three-quarters of the vulcanized values. Some belt man ufacturers can get adequate fastener holding due to their weave, and no reduction in the rating is required. 

Comments

Popular posts from this blog

CRYSTALLIZER DESIGN CALCULATION

Given Data Solute                                                                    : A Solvent                                                                  : B Concentration of Solute                         ...

DESIGN CALCULATION FOR COAL BURNING BOILER FIRE GRATE AREA

DESIGN CALCULATION FOR COAL BURNING BOILER FIRE GRATE AREA   Heat Required                 : 200,000 Kcal/hr Coal                                 : 4500 Kcal/hr Coal Efficiency               : 72% Size of Coal Required      : 1.5” to 3” Coal Burning Capacity of a Grate : 15 lb/ft 2 Distillation Column   If you need in PDF format please click or copy & paste on your address bar the following link: https://drive.google.com/open?id=1vk96TnaMvwOjP5MGVKen-Px3JA4Y_-2E

Dimensions of Dished Ends for Pressure Vessels like Boiler, Reactor, Storage Tank

According to IS 4049 (Part-2): 1996 and Table 2 Dimensions for Dished and Flanged Ends (Torispherical) Inside Crown Radius is 80% of ID Inside knuckles Radius is 10% of ID and in no case less than 6% nor less than 3 x thickness of Dish.   Inside height of Dish can be calculated according to IS: 2825 – 1969 and IS 4049 (Part-2) : 1996 as follows: Now the Inside height can be calculated according to IS: 4179 – 1997 which is as follows:  When Knuckle Radius is 10% of ID           2. When Knuckle Radius is 6% of ID           Where h i = Inside height of Dish                       R i = Crown Radius of Dish                       r i = Knuckle radius of Dish ...